MODEL NO. SIP220
PORTABLE DOCKING STATION FOR iPOD
INSTRUCTION MANUAL
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
Warnings and Precautions
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
This symbol, located on back or bottom of the unit, is intended to alert the
user to the presence of un-insulated “dangerous voltage” within the produc’ts’s
enclosure that may be of sufficient magnitude to constitute a risk of electric
shock to persons.
This symbol, located on back or bottom of the unit, is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
Any use of the controls or an adjustment to the procedures other than those
specified herein may result in hazardous radiation.
CAUTION : TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE
OF PLUG TO WIDE SLOT, FULLY INSERT.
To reduce the risk of electric shock, do not remove cover (or back). There are no
user-serviceable parts inside. Please refer any servicing to qualified service personnel.
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designedo provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between he equipment and receiver.
• Connect he equipment into an outlet on a circuit different from that to which the
receiver s connected.
• Consult the dealer or an experienced radio/TV technician for help.
Features
Peripherals
WARNING: Danger of explosion
if batteries are incorrectly installed.
Replace only with the same or
equivalent type.
The button cell battery contains
mercury. Do not put in the trash,
instead recycle or dispose of as
hazardous waste.
POWER
DISP
M-UP
FUNC
iPod
M-DN
REPEAT
BAND
MENU
SELECT
MENU
MEM/CLK SET
MENU
SHUFFLE
PLAY LIST
EQ
ALBUM
VOL
SNOOZE
SET
ALARM
SLEEP
Notes: NOTES: Buttons that are not defined in the Periperals section, are defined in the
Features section.
Peripheral Defined
22 REPEAT Press the REPEAT button to switch between REPEAT 1, REPEAT ALL, or Off (iPod playing
only).
23 MUTE Press the MUTE button to decrease the volume entirely.
24 DISP (DISPLAY) In radio mode press the DISP button to switch between viewing the time or the radio
frequency.
25 MEM/CLK SET Press the MEM/CLK SET button to program a radio station into the presets or to adjust
the clock. In iPod mode, press the MEM/CLK SET button to enter the menu on an iPod.
26 SHUFFLE Press the SHUFFLE button to randomly play songs on an iPod.
27 PLAYLIST Press up on the PLAYLIST button to cycle up through the playlists on an iPod, or press down
on the PLAYLIST button to cycle down through the playlists on an iPod.
28 ALBUM Press up on the ALBUM button to increase the album number, or press down on the ALBUM
button to decrease the album number.
29 iPod Press the iPOD button to power on an iPod and enable control through the player.
30 STOP/BAND Press the STOP/BAND button to stop a song on an iPod or press the iPod/Band button,with
the radio function on,to switch between AM and FM frequencies
31 Navigation Controls/SELECT Use the Navigation Controls to move through an iPod menu system. Press
the SELECT button to select a song, photo, or video on our iPod.
iPod Insert
6. iPod photo, Color U2 iPod 20 GB,
30GB
7. iPod photo 40GB, 60GB
8. 1G iPod nano 2GB, 4GB
9. iPod with video 30GB
10. iPod with video 60 GB, 80GB
11. 2G iPod nano 2GB, 4GB, 8GB
1. 3G iPod 10GB, 15 GB, 20 GB
2. 3G iPod 30 GB, 40GB
3. iPod mini 4GB, 6GB
4. 4G iPod, U2 I pod 20GB
5. 4G iPod 40GB
NOTES: The number engrave in the backside of the inserts.
Installing a Battery in the Remote
Warning
There is danger of an explosion if you replace the battery
incorrectly. Replace only with the same or equivalent battery.
3
2
1
LITHIUM BATTERY
CR2025
3V
To install or replace the battery:
1
2
Pull the battery tray out of the remote.
If you are replacing the battery, remove the old battery and
dispose of it properly. Note the orientation of the + and - sides of
the battery.
3
4
Insert the new battery into the battery tray, orienting it the same
way the old battery was placed.
Close the battery tray.
Operations
Setting the Clock
a. With the power off, hold the CLOCK SET button.
b. Press the SEARCH/TUNE down or up buttons to toggle between 12HR and 24HR
time, and press the MEM/CLK SET button to select either option.
c. Press the SEARCH/TUNE up button to cycle up through the hours, or press the
SEARCH/TUNE down button to cycle down through the hours. Press the MEM/
CLK SET button to select the hour.
d. Press the SEARCH/TUNE up button to cycle up through the minutes, or press the
SEARCH/TUNE down button to cycle down through the minutes. Press the MEM/
CLK SET button to select the minute, and finish setting the time.
Setting the Alarm
a. Press the ALARM SET 1 button.
b. Press and hold he ALARM SET 1 button.
c. Press the SEARCH/TUNE up button to cycle up through the hours, or press the
SEARCH/TUNE down button to cycle down through the hours. Press the ALARM
SET 1 button to select the hour.
d. Press the SEARCH/TUNE up button to cycle up through the minutes, or press the
SEARCH/TUNE down button to cycle down through the minutes. Press the ALARM
SET 1 button to select he minute.
e. Press the SEARCH/TUNE up button to cycle up through the different alarm modes
(Radio, Buzzer, or iPod). After a mode is selected press the ALARM SET 1 button
to finish setting the alarm.
NOTES: This operation also applies to setting alarm two.
continued
Operations
Connecting Other Digital Audio Devices
a. Use a line-in cord to connect an iPod shuffle or other audio device to the AUX-IN
port.
b. Press the FUNCTION button to activate the AUX-IN.
c. The iPod shuffle or other audio device will now play through the speakers of the
unit.
How to Using Radio
a. Power on the unit, press the FUNCTION button to radio mode.
b. Using the BAND button to switch between AM / FM Band.
c. Automatic Tuning - Press and hold the SEARCH/TUNE up or down buttons until
the display begins to move, then release the buttons. The tuner will scan up or down
the band until it finds the first strong station, and then stop on that station. Repeat this
process until the tuner stops on your desired station.
d. Manual Tuning - Press and release the SEARCH/TUNE up or down buttons repeatedly
until the display is showing the frequency of your desired station. Use the manual
tuning method to tune to weaker stations that are bypassed during Automatic Tuning.
Antennas AM - If reception is weak, turn the unit to improve reception. FM - If
reception is weak, adjust FM Wire Antenna length and the angle to improve reception.
Programming radio station presets
You can program as many as 10 FM and 10 AM radio station presets.
a. During RADIO mode, press BAND button to select AM/FM band.
b. Press the SEARCH/TUNE up or down buttons to desire station you want store.
c. Press and hold the MEM/CLK SET button to activate the programming mode.
d. Press the SEARCH/TUNE up or down buttons to select the preset number you want
to store.
e. Press and hold the MEM/CLK SET button to store the station.
f. Repeat Steps “b” through “e” to program additional presets.
To recall the radio station preset
pPrreessesttnhuemMb-eDrNyo(RuEwAaPntEaApTp)eaorrsMon-UthPe(dPiLspAlYay/PaAnUdSthEe/Pp+re)sBetustttoatniornepweailtlebdelysouunntidl.the
Specifications
Power Requirement
Input:
AC~120V/60Hz
2 x DC 1.5V ”AA” (LR-6) Size Batteries
Battery Back-up for Clock:
Battery CR2025 for remote control handset
Frequency Range
Radio Receiving:
AM 530 - 1710 KHz
FM 87.5 - 108 MHz
Power Consumption
20 Watts
LIMITED PRODUCT WARRANTY
This quality product is warranted to be free from manufacturer’s defects in material and workman-ship,
provided that the unit is used under the normal operating conditions intended by the manufacturer.
Should you have any problem with this product, please and it is highly recommended to visit our website at
operating manuals and trouble shooting tips on our website which gives you the answer on most of the
questions you could have in operating the unit.
TERMS OF WARRANTY
C.I. Service Dept. warrants this product to be free from defects in materials and workmanship for 90 days on
parts and 90 days on labor. If you originally purchased your product more than 90 days ago, a repair fee
may apply.
Nothing within this warranty shall imply that C.I. will be responsible or liable for any damage to any items
placed in this product, whether due to any defect of the product, or its use, whether proper or improper.
EXCLUSIONS
Save as herein provided, C.I. Service Dept. (Canada) or C.I. Service Dept. (USA), there are no other
warranties, conditions, representations or guarantees, express or implied, made or intended by C.I. or its
authorized distributors and all other warranties, conditions, representations or guarantees, including any
warranties, conditions, representations or guarantees under any Sale of Goods Act or like legislation or
statue is hereby expressly excluded. Save as herein provided, C.I. Service Dept. (Canada) or C.I. Service
Dept. (USA), shall not be responsible for any damages to persons or property, including the unit itself,
howsoever caused or any consequential damages arising from the malfunction of the unit and by the
purchase of the unit, the purchaser does hereby agree to indemnify and save harmless C.I. from any claim
for damages to persons or property caused by the unit.
TO OBTAIN REPAIRS UNDER THE TERMS OF THIS WARRANTY
1. The original purchaser must present a copy of the original bill of sale and the service warranty card.
2. Any alterations, abuse, misuse, battery corrosion or accidental damage voids the warranty.
3. The warranty does not cover cabinets and accessories.
4. No warranty or insurance contained or set out shall apply when damage or repair is caused by power
failure; damage in transit or when moving the unit; improper power supply; use for commercial or
industrial purposes; service calls resulting in customer education, etc.
5. The defective product should be mailed to:
Canada
C.I. Service Dept.
315 Attwell Dr
U.S.A
C.I. Service Dept.
2215 Kenmore Avenue
Ste 100
Buffalo, N.Y.
Toronto, Ontario
M9W 5C1
14207
For service assistance and product information, please call: 1-800-968-9853.
If mailing the product, the freight must be prepaid and a money order for $7.00 should be included
to cover the cost of insurance and the return of the product.
6. C.I. reserves the right to repair or replace the parts which have become defective.
Model No.
Date Purchased
Serial No.
is a registered trademark of OSRAM SYLVANIS Inc. used under licence.
|